Articles regarding Active Pour Tap
If your beer is too frothy at the point of dispense this may be due to the following reasons:. Conditioning your Brew is a vital step. It adds key tasting notes to your Beer or Cider and allows the CO2 produced naturally by the yeast during the ferme
We are very sorry that your Tap Handle for your Active Pour Tap has broken. The most common reason for this to happen is the Tap Handle being put on and used back to front. Please ensure the screw is facing backwards, so not visible from the front of
A small drip is to be expected after dispensing from your Pinter using the Active Pour Tap. This is perfectly normal and isn't anything to worry about. Please simply leave your glass underneath for a couple of seconds to allow the last few drips to f
We are sorry to hear you are unable to remove your Active Puor Tap from your Pinter. Not to worry, I am sure this Troubleshooting Guide will help!. The Active Pour Tap can sometimes be a little tricky to remove at times, especially if any residual br
No, you don’t need to purchase the Pinter and the Active Pour Tap separately – the Active Pour Tap is included as standard with the Pinter 3, so there’s no need to buy one in addition. If you have a Pinter 2 and would like to upgrade your tap, the Ac
The new Active Pour Tap puts you in complete control of the beer you serve. It adapts to any pressure state inside the Pinter. All you need to do is pull the handle. You can slow the flow when your beer is freshly brewed and you can open up fully whe
If you find that your Active Pour Tap has stopped pouring this could be an issue with one of the following. If your Pinter is nearly empty then the pressure inside will have naturally decreased. You may need to open the Carbonation Dial on the back t
The Active Pour Tap comes as standard with the Pinter 3 and is fully compatible with the Pinter 2. You can upgrade your Pinter 2 by ordering it through our website here.
Your Tap Collar should be completely flush with the Pinter. Please completely remove your Tap and re-try attaching it to see if you can settle it properly into its threading. If you find your Tap Collar is getting stuck when screwing it into the Pint